Enclosure Front Panel

Note

This page includes information regarding both the original Makito X1 chassis and the Makito X1 chassis v2. The Network connector and DC IN/IO connector on v2 have been changed in order to meet higher vibration requirements.

The Makito X1 Rugged enclosure provides rugged connectors for connecting the encoder's Power/Audio/Serial inputs, Video input, and Network interface, located on the front panel. There is one LED that indicates the power status.

MX1 Rugged v2 (#S-MX1E-R-V2-SDI1)	MX1 Rugged (#S-MX1E-R-SDI1)

Connectors

Connector	Description	Number of Contacts
DC IN and I/O Connector	Hirose P/N LF13WBRB – 11S	11
DC IN and I/O Connector v2	Lemo P/N HEN.2M.312.XLNP	12
Video Input Connector	Coax BNC Jack Amphenol P/N 31-70551-12G	1
Network Connector	Hirose P/N LF10WBRB – 12S	12
Network Connector v2	Lemo P/N HEP.2M.312.XLNP	12

LED Status Indicator

Function	Description	Indication
STATUS	Off	No power
	Green fast blinking	Reset button is pressed for less than four seconds. If the Reset button is not pressed, there is a power fault.
	Green slow blinking	Booting/Initialization
	Green solid	Booting/Initialization sequence is complete (No fault/OK).
	Orange fast blinking	Reset button is pressed for more than five seconds (Factory Reset enabled). After Orange fast blinking, the LED turns off, stays off for a while, and then starts Green slow blinking towards the end of the booting up.