Ensure that auto-save is enabled at startup so that your configurations aren't lost on a reset, reboot or power loss. See Saving and Loading Presets.
Review these tips and recommendations if you are having issues rebooting or resetting your Makito FX.
Resets
When performing a Factory Reset, do not remove or disconnect the power supply until the reset is complete.
Factory Resets restore the default accounts and passwords. Any changes to the default passwords, created accounts, and deleted default accounts will be lost after a Factory Reset or a firmware downgrade.
Reboots
Reboots are required to make the following changes:
When you make changes to the Network settings, be sure to write down the new encoder IP Address or label the chassis before rebooting. After you apply your changes and reboot, you will have to redirect the browser to the new IP address and sign in again to access the encoder.
If you are connecting to the encoder through an IPv4 connection, disabling the IPv4 interface will drop your connection after a reboot. You will need to reconnect using IPv6 or the serial interface (if available).
