Skip to main content

service

Important

(Makito X4 Rugged Encoder only) If the COM1 port is not configured for CLI Management, and all remote management interfaces (HTTP, telnet, SSH, and SNMP) are disabled, the only way to re-enable these services is by a Factory Reset. Once the serial port is configured for metadata or passthrough use, it is no longer usable for CLI management.

For security purposes, you may need to stop one or more network services from accessing the Makito X device. The service command is used to enable and disable the following network services: all, or (depending on the platform) AUDIT, EMS, HTTP, ONVIF, PREVIEW, NMOS, RTSP, SNMP, SSH, and TELNET.

Caution

Take care not to disable all network services; you must at least keep http (Web interface), telnet , or ssh active. Otherwise you will lose access control to the unit, and the only way to re-enable these services is by a Factory Reset.

Synopsis 

service svcname action

where (depending on the platform):

svcname can be: all, audit, ems, http, onvif, preview, nmos, rtsp, snmp, ssh, telnet

Actions

ActionDescription

start

Activates the service immediately and configures the unit so that the service will be started automatically when the unit is rebooted.

stop

De-activates the service immediately and configures the unit so that the service will be disabled when the unit is rebooted.

restart

Restarts the service and configures the unit so that the service will be started automatically when the unit is rebooted.

status

Displays the current status of the service, i.e., if it has been started or stopped. Also displays the startup status of the service.

Examples

# service all status

Displays information about all services, such as:

audit service is currently enabled
audit service is enabled at system startup
ems service is currently enabled
ems service is enabled at system startup
http service is currently enabled
http service is enabled at system startup
onvif service is currently disabled
onvif service is disabled at system startup
preview service is currently disabled
preview service is disabled at system startup
nmos service is currently disabled
nmos service is disabled at system startup
rtsp service is currently disabled
rtsp service is disabled at system startup
snmp service is currently enabled
snmp service is enabled at system startup
ssh service is currently enabled
ssh service is enabled at system startup
telnet service is currently enabled
telnet service is enabled at system startup
# service telnet stop

Stops telnet connection to the Makito X4.

# service telnet restart

Re-starts telnet connections to the Makito X4.

        
      


Tip

On the Makito X4 Rugged, pass-through allows the serial port to be used as a pass-through interface to control serially attached devices, such as PTZ controlled cameras. 

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.